Jan
16
2021
CPE is chlorinated polyethylene, which is made by chlorinating special high-density polyet
Jan
15
2021
Plastic extruder is a kind of common plastic machinery and equipment. During the daily ope
Jan
14
2021
Technical characteristics of gas-assisted injection moulding (1) The design of the mold ca
Jan
13
2021
1. Shortage Failure analysis and troubleshooting methods: (1) Improper control of process
Jan
12
2021
With the popularization and use of full hydraulic injection molding machines, some users r
Jan
11
2021
The clamping process is generally divided into three or four stages, which is generally fa
Jan
09
2021
In order to eliminate or reduce the faults in use as much as possible, the following matte
Jan
08
2021
1. Wall rupture This kind of defect generally appears on the side wall near the corner of
Jan
07
2021
The residual stress is too high. When the residual stress in the plastic part is higher th
Jan
06
2021
Jetting, also known as jetting marks and jetting drool, refers to the 65-thread-like strea
Jan
05
2021
Two-color injection molding is the realization of a part with two kinds of plastic injecti
Jan
04
2021
When the cavity is almost full during the injection filling process, the movement of the s